I have a DC18 Dyson vacuum, where motor overheats and it shuts down after a few mins(4-5mins).
It doesn't happen immediately, brush rolls and its sound changes like it's about to die and then it'll shut off.
Cleaned all the wand, pipes, lower brush area and all filters. If I remove the whole cyclone and filter body, then turn it on there's a lot of suction on the hole which goes into the cyclone. While running, wand has very minimum suction.
I feel like, there's some blocking, maybe in the lower ball area, is there a way I can validate it? Thank you for the advise and help.
It doesn't happen immediately, brush rolls and its sound changes like it's about to die and then it'll shut off.
Cleaned all the wand, pipes, lower brush area and all filters. If I remove the whole cyclone and filter body, then turn it on there's a lot of suction on the hole which goes into the cyclone. While running, wand has very minimum suction.
I feel like, there's some blocking, maybe in the lower ball area, is there a way I can validate it? Thank you for the advise and help.