Recent content by Ducati996

  1. D

    Lug Nuts Seizing Up

    I always add a fro of oil to threads & taper seat then run them down lightly with impact. I then torque to spec or slightly less because of lubricant & I always make sure the nuts actually move & tighten to spec. Putting a torque wrench on a nut & hearing it click without turning is not...
  2. D

    Mower losing coolant

    I bought the same machine a couple years ago and had the same problem. After 3 years I finally found where the very small leak was coming from. After it sat the winter in my conex when I checked it prior to starting the coolant was low and a spot was on the floor. I put mine on an auto lift to...
  3. D

    Project Farm - Tests Pennzoil Motor Oil

    When I bought my 2016 Volvo XC60 Pennzoil Ultra was the only oil I could find that had the A5/B5 approval. The engine is 2.0 liters and is rated at 300 hp & 300 lb/ft torque being turbo charged and super charged. I changed the oil and embarked on a cross country trip pulling a small v nose...
  4. D

    Brake Fluid Exchange Tool

  5. D

    Best Hydrostat fluid?

    I service a lot of vehicles & equipment, when my buddy bought a kubota hydrostatic tractor I went on the forums to find a suitable hydrostatic oil. Kubota owners are adamant about using their Super UDT ONLY in their transmissions. Many have said they tried other cheaper brands only to drain it...
  6. D

    Recent experience with reman calipers?

    I have found that many calipers reman or new have only enough lubricant (if any) for assembly. I pull the boot back and add additional lubricant to prevent premature sticking. Never had one fail that I gave additional love!! 90cummins
  7. D

    Is Red Line MTL 70W80 ok to use in an NV4500 manual transmission?

    I retrofitted the NV4500 into my Dodge in 1999 to replace the failed Getrag. . I purchased it thru Advance Adaptors. I’m aware of the necessity to use the proper oil. Red line doesn’t show the MTL 70w80 because it’s several years old. Was hoping I could use it. I would not use anything not...
  8. D

    Is Red Line MTL 70W80 ok to use in an NV4500 manual transmission?

    I have 1990 Dodge W350 with an NV4500 manual transmission that requires redline MT 85 oil or equivalent. I have several quasars of redline MTL 70w80 GL-4 gear oil which is slightly lighter. Are they interchangeable? This is not a work truck. It is driven only for pleasure.
  9. D

    Moly Grease for Dana/Spicer U Joints?

    I’ve used moly 5% or less for approximately 30 years in my 1990 dodge w250 4x4 diesel. This vehicle has been loaded far beyond its legal capacity and the rear driveshaft unjoints have never been replaced and currently have 250k + miles on them. In an application that is always loaded the...
  10. D

    Small data point: How long does it take for a sway bar end link to fail after the grease leaks out? 2 years.

    Biggest variable is operating environment. Arizona could be many years North East a year or two. 90cummins
  11. D

    moly grease with bronze bushings?

    I used NUSHINGS $65.00 which are bushings made from engineered plastic on my 2002 BMW 1150 GS. 20k miles zero wear. Excellent product fantastic price. Copy & paste link. https://nushings.com/#/
  12. D

    Different between AW 46 hydraulic oil and tractor hydraulic

    I haven't been here in quite a while I have a 22 gpm pump.
  13. D

    How Often Do You Check Your Oil?

    I have always checked the oil & fluid levels in my vehicles, I would pull the dipstick and feel the oil between my fingers until I bought a 2016 Volvo XC60 with the 300hp 2.0 liter engine. I was disgusted when I found out it had no dip stick and there was a wait period after shutting it down to...
  14. D

    Different between AW 46 hydraulic oil and tractor hydraulic

    I built a log splitter over 35 years ago with 22 gpm pump that has been flawless. It has split many hundreds of cords for myself and family members. It has been well maintained with fluid and filter changes which is approx 10~15 gallons. I have a Ford 1720 tractor and also service and repair...
  15. D

    Kohler CV20 Burning Oil - New Holland LS45

    I have a 61" Scag with a CV22S 22 hp command engine which had 3000 hours on it was very tired but ran ok. I rebuilt it and it runs like new. It is doubtful yours has as many hours as mine so are-ring and reseal job along with a valve grind should take care of your problems.
Back
Top Bottom