If all else fails, remove brake caliper and rotor. Separate steering nuckle from tie rod end, lower ball joint, and strut. Pry axle shaft from transaxle and take entire assembly to a shop with a hydralic press to press out axle shaft from steering nuckle and bearing.
Hi Emory, I have the same car. Bought it new and now have 120,000 miles on it. The transmission has a screen so a filter kit is not needed and the screen cannot be replaced without partial trans disassembly. Simply drain it and refil with Dextron III. Buy 5 quarts just in case. Do this every...
This is the first uoa on my 2005 PT Cruiser GT Convertible. Total miles were 25,083 with 4948 miles on oil. Oil in use from 5/18/06 to 9/9/06. Baldwin B243 oil filter and Valvoline Durablend 5W30 SM. Second run of Durablend. Previous run was with Pure One. Element not listed were zero.
Aluminum...
This oil sample had a trace of insolubles. Other than that nothing much showed up. Analysis by Blackstone. Elements not listed were 0.
Moly 40
Boron 31
Calcium 878
Mag 3
Phos 400
Zinc 465
Flashpoint 385
Viscosity was 70.1 SUS @ 210 F (65-76)
Trace of insolubles
I was disappointed in the...
Well it looks like we found the Penzoil motor oil that causes sludge. Are you sure this was not some Penzoil SB 30 weight motor oil from 1965. It is really hard to believe that the #1 seller of motor oil in USA would make a mistake like this. It has always been my opinion to never trust the...
In my opinion Castrol Startup is snake oil. I tried it in my car that has a history of timing chain/valve rattle or rod knock at startup. The 10W40 Castrol startup was no better at reducing startup noise than 5W30 pcmo. Even tried it with 2 diffeent oil filters, Beck/arney and STP. Drained it...
I would recommend Valvoline Maxlife for your 2.4 L engine in the Dodge. I use Maxlife 10W30 in a 2003 PT Cruiser with the same engine and run it to 6000 miles. Check out my UOA for the PT cruiser. It was much better than I ever expected. Good Luck.
I have a 93 Nissan p/u with the 2.4 engine. I use dino and always run 4000 to 5000 mile oil changes. Occasionally after an oil and filter change I would get a hydralic valve lifter ticking. When this happens I add about 8 ounces of Rislone from the yellow quart bottle. One drive to work and back...
Hey Rob, What kind of car and engine does it have that is giving you start up noise and what weight of Havoline you went to.
I have a 2000 Infiniti G20 that has made startup noise since 5000 miles and am still not completely satisfied with any oil and filter that I have used.
I plan to keep the interval at 6000 miles for now because that is the maximum recommended change interval. I am really satisfied with 1/2 quart in 6000 miles coupled with the very low wear, high remaining TBN, and this oil did not shear down. I won't be using any other additives.
Here is my analysis on my 2003 PT Cruiser with 2.4 non turbo dohc engine. This was second interval with Valvoline Max Life 10W30 and Pure One oil filter. First is my sample, second is universal averages.
Aluminum 2 4
Chromium 0 1
iron 5 19
Copper 1 7
Lead 0 2
Tin 0 1
Moly 2 15
Nickel 0 0...
I changed the timing belt on a 95 Accord last year. It had a manual transmission. I had to have a friend jam the flywheel with a pry bar. I placed a floor jack under the engine oil pan to keep the engine from rotating on its mounts. I used a 17 mm 6 point impact socket, 1/2 inch drive flex...
Before you use the Auto-RX you could just run the Mobil DC until it is a quart low and then change out the oil only for a high mileage oil. I am partial to Valvoline Max Life and have personally had very good results with it. A second option would be to just add 1/2 or 1 quart of a high mileage...