- Joined
- Aug 4, 2021
- Messages
- 1,283
I remember on the older OBD1 scanners, circa 1985, when plugged into the ALDC under the dash, TPS was shown on the scanner itself as A voltage, ~ 1/2 volt at idle to ~ 5 volts at full throttle.
In Torque Pro app, it shows the TPS value in percentage, not in volts. I looked and looked in the torque app settings and can't see anywhere to assign the display to read in volts. Do you know if it's possible to make/set up torque pro to display TPS readings in volts instead of percentage?
In Torque Pro app, it shows the TPS value in percentage, not in volts. I looked and looked in the torque app settings and can't see anywhere to assign the display to read in volts. Do you know if it's possible to make/set up torque pro to display TPS readings in volts instead of percentage?