So I'm continuing with my toolbox reorganization and cleanup. Based on everyone's input I've relegated most of my nut drivers to "not in the toolbox" status. I've kept common hose clamp sizes but the rest are gone. I will rely on my 1/4" sockets. Thinking of doing something similar with my Torx drivers since I can't really remember the last time I used them (except on appliances). Once again looking for the collective wisdom and experience of the group. As a side note, I still would have 3/8" Torx sockets in the box (for now). My box is in my garage and is primarily meant for automotive work and "outside" work. Thanks for everyone's feedback.