quote:
Originally posted by TGP:
I have a 96 Pontiac Sunfire, 2.2litre with a manual transmission which calls for GM Syncromesh in the tranny. I would like to switch to a synthetic gear oil for the tranny. What weight would be safe to run in it? There is no weight listed on the GM Syncromesh bottle. Any info on this would be greatly appreciated.
Here are the full specs for your car.
1996 PONTIAC SUNFIRE 2.2L 4-cyl VIN Code 4
FILTERS
Oil Filter......SDF29
Oil Vapor Filter......N/R
Air Filter......TS87
Fuel Filter......GF258
Fuel Vapor Filter......N/R
PCV Valve......HV124
Trans......TF77, 3 Spd.
Trans......TF157, 4 Spd.
BOSCH SPARK PLUGS
SE
Wire......B09374
Plug......B4469
BOSCH WIPER BLADES
Driver side......B40922
Passenger side......B40917
CHASSIS LUBRICATION
0-4 Fittings, 0 Plugs..........LB
Series 2000 Synthetic Racing Grease
Synthetic GHD Heavy-Duty EP Grease
Synthetic Multi-Purpose Grease NLGI #2
LUBRICANTS & FLUIDS
Engine Oil
Grade 1......API*
Series 2000 Synthetic 0W-30 Motor Oil
SAE 5W-30 Synthetic Motor Oil
SAE 5W-30 XL-7500 Synthetic Motor Oil
Series 3000 Synthetic 5W-30 Heavy Duty Diesel Oil
Above 0°F......10W-30
All Temps......5W-30[1]
Manual Transmission,5-spd.....GLS[2]
SAE 5W-30 Synthetic Motor Oil
http://www.amsoil.com/products/hdd.htm
SAE 5W-30 XL-7500 Synthetic Motor Oil
Automatic Transmission.....AF3
Synthetic Automatic Transmission Fluid
Fluids
Power Steering Fluid.....PS
Power Steering Fluid - Not Available Through Amsoil Click here for more information
Brake Fluid.....HB
Hydraulic Brake Fluid, DOT-3 - Not Available Through Amsoil Click here for more information
Clutch Fluid.....HB
Hydraulic Brake Fluid, DOT-3 - Not Available Through Amsoil Click here for more information
1. SAE 5W-30 is preferred.
2. GLS is a special gear lube, GM part no. 12345349 (5-spd).
CAPACITIES
Engine, without filter..........4.0 quarts[1]
Cooling System, Initial Fill..........11.0 quarts
Automatic Transmission, 125 (3T40) Initial Fill..........4.0 quarts[2]
Automatic Transmission, 4T40E,-45E Initial Fill..........6.9 quarts[2][3]
Automatic Transmission, Total Fill
3 speed 3T40..........9.0 quarts
4 speed 4T40E..........13.0 quarts
3 speed THM 125..........9.0 quarts
Manual Transmission, 5-spd Isuzu..........4.0 pints[4]
Manual Transmission, 5-spd Others..........4.4 pints[5]
1. Capacity shown does not include filter. When replacing
filter additional oil may be needed. After refill check oil
level.
2. With the engine automatic transmission operating temp, shift transmission
through all gears. Let engine slow idle in PARK for at
least 3 minutes. Check fluid level and add fluid as needed.
Do not overfill.
3. 4-speed transaxle does not have a dipstick. Fluid should be
be automatic transmission the level of the fill plug located automatic transmission the lower
right of the passenger side driveshaft.
4. Identification: Isuzu has a 7-bolt aluminum end cap, Muncie
has a 9-bolt steel end cap.
5. Identification: Isuzu has a 7-bolt aluminum end cap, Others
have a 9-bolt steel end cap.
TORQUES
Oil Drain Plug.....35 ft-lbs
Manual Transmission 5-spd Muncie
Drain Plug.....18 ft-lbs
Manual Transmission 5-spd Isuzu
Manual Transmission 5-spd Getrag
Drain Plug.....18 ft-lbs
Manual Transmission 5-spd NV
Drain Plug.....18 ft-lbs
CAUTIONS
CHASSIS
Do not lubricate ball joints if their
temperature is below degrees C -12
or damage to the joint may occur.
COOLING
When inspecting coolant, check it's color.
If coolant is orange, do not install or
top-off with green colored coolants.
SERVICE INTERVAL
http://www.amsoil.com/lit/g1490.pdf