rope plug ?

Status
Not open for further replies.

Ndx

Joined
Apr 4, 2008
Messages
1,938
Location
IL
Hey Guys,

Just patched a hole but I think I pushed rope to deep i had very little sticking out when I was cutting it flat...

Should I be concerned about this ?
Will this possibly make tire out of balance or woble inside ?

I'm paranoic
 
Yeah actually I found manual it says when 2/3 is in so I think I'm spot on ...

Only part I messed up is twisting it says not to twist ... I guess if it will leak I will get it fixed properly

Thank you
 
you did fix it properly
smile.gif


If it is still holding air in the morning then I bet it will be fine for years.
 
OK, I guess I've got to comment.

Plugs are considered temporary repairs. That's because they tend to leak - and not necessarily right away.

The proper way to repair a tire is with a plug/patch combination. The patch seals the tire and bridges the damaged area, and the plug fills the hole from outside contaminants.
 
Originally Posted By: CapriRacer
OK, I guess I've got to comment.

Plugs are considered temporary repairs. That's because they tend to leak - and not necessarily right away.

The proper way to repair a tire is with a plug/patch combination. The patch seals the tire and bridges the damaged area, and the plug fills the hole from outside contaminants.


+1

Plugs will leak again some day...
 
If your rope plugs are leaking it is because you did it wrong. The repair is temporary because tires are temporary.

I have plugged many many many tires. ONE failed to hold the plug correctly. When I say many many many, I am conservatively guessing that I have used over 150 plugs. Never had a blowout, leak, or any other problem with the tires that got plugs. The one that wouldn't take a plug was because the tire was defective and the rubber was very weak in the spot where I tried to insert the plug. The massive tire industry preys on the people that think only tires with under 10,000 miles from a big manufacturer is safe.
 
I put two rope plugs in a Goodyear ComforTred that I pulled a chunk of metal out of.

I only did it to avoid putting on the donut spare, to see if I could buy enough time to get a new tire bought.

It never leaked, it held, and that tire was still on the car when I sold it... a couple of years later.

When I used rope plugs, I use a layer of rubber cement when inserting the plug, and wait an hour before putting air in the tire and re-installing it. It is is cold, I'll warm the area being repaired.
 
Yup, plugs are not the "approved" way to repair a tire, but they work fine. I have one in a tire on my Sonata that I put in and it has about 30k miles on it.

I worked in a tire shop about 8 years ago and we installed many hundreds of plugs with good results. A patch/plug can also leak over time, too.

Plugs aren't the best repair, but they can and do work.
 
Plugs can and will work, but if a customer wants a tire plugged, I say sure, but you will have to do it yourself. Too many variables, mostly when someone says I didn't drive on it very far flat, and you dismount the tire only to find enough rubber crumbs to fill up a coffee can. Good luck trying to remove a bent deck screw at a 45 degree angle with the head wore off so you can plug it without making 2 holes in the tire. If you insist on plugging, a carbide 1/4 in. pointed reamer on a drill makes it a lot easier, although I only plug lawnmower tires. Every hole is different.
 
Status
Not open for further replies.
Back
Top Bottom