Search results

I'm out of the loop on this issue I have a Fram Ultra I bought in August 3, 2024, would this be affected?

I removed EVERY RATTLE from the unit. Very very smooth now! 100ft 6 AWG SEOW Cord coming in so I can connect to the house without moving it

The last owner had a Baldwin B161-S, and I just bought more of them as they were a good deal and seem well regarded Unknown oil, it only has 100 hours on it since the last owner changed the oil and filter, and Kubota now says 1000 hour OCI, so I don't really want to change it just yet. I...

https://bobistheoilguy.com/forums/threads/2021-generac-rg027-qs-generator-208-hours-total-5w30-hurricane-beryl-run.386132/

For some generators it does make sense. The air cooled Generac's seem to have a tendency to not get to temp during their short 6 min run cycle and end up full of condensation somehow This unit however does not have that issue

The reason not is that it states a 125 OCI, but last time I went well over that to 168 and an analysis showed it still good

For my Generac Generator. Mitsubishi 4G64 2.4L Engine at 1800RPM I've had just 33 hours on it this year, and its now at the 1 year mark. Filled with Kirkland 5W-30 Synthetic Would you swap or leave it? I will leave the filter for sure

This thing does not roll easy over grass! Taking it on a trip through the yard so it can be in its permanent storage location, and in a more shady area so its easier to work on

New fenders arrived. Put them on and then took them right back off again to clean up some more rust

Got the coolant plug out so I could install a block heater

Pausing Payments, just like everyone who has an Altima at 25% APR with a perpetual temp tag

I have a light tower that will live in my yard, and odds are it never moves. But its possible it would get towed somewhere once or twice. It has really old, super dry rotted tires Can anyone weigh in on Radial vs Bias ply tires? I heard that Bias ply holds up better over time, even though you...

Generac/Marathon MLT3060K Light Tower Kubota D1005 3 Cylinder 1.0L 1800RPM Out: Unknown Red Coolant In: Peak Final Charge Pro-Series POAT Spilled most of it on the floor, good job

I think 1000 is still not aggressive enough, but we're getting somewhere

Haha, I tried some 2000 grit sanding discs today, and it is quicker than the compound, but I still need to go deeper, may get some 1000 grit, would 500 grit be too far?

Coolant change done. Drained, and flushed twice with distilled water, then filled back up

Well, lets just say the petcock never went in... Lots of struggling later, I re-tapped it with 1/4-18 NPT and luckily it came good

Works great for popcorn

Any problem mixing Kirland 15W-40 and the Rotella?

Not too thin? IIRC it calls for 15W-40 or 10W-30