Recent content by WesternReach

Thanks everybody for the replies And tips. I’ll be trying these out as soon as the weather clears

Thank you for the clarification

Thank you for that idea, I just might try that. Any suggestions for the type of drill bit to use and if I should some type of cutting paste?

Thanks everyone for the replies, I will try them until I get it done.

Yes, trying to remove old starter & bolt snapped off at the head. Two other bolts are already removed, starter won’t budge. I assume the snapped bolt is still holding the starter in?

The other two bolts came out easily. However the snapped one is still threaded inside the starter “ear” (bolt snapped off at the head)

Hi Looking to remove a snapped starter bolt on a 2003 mercury grand Marquis. What’s the best way to go about this? Been soaking it with penetrating oil. See pictures highlighted in red. Thanks

Good points, I think I will give it a try.

Hopefully it doesn’t get that cold. And if it does, I will stay home. Lol

I figure it’s a small price for (hopefully) a lot of benefits to the engine

New York City

Hi 2008 Chrysler Sebring 2.4 liter 4 cyl. Although owners manual calls for 5w20. Can I use 10w40 or 10w30 for this upcoming oil change? I have an enough of this on hand , just wondering if it’s a mistake to use. I change the oil and filter every 2,500 miles. Thanks

Ok then I won’t, but so far ATF is ok?

Thanks everyone for the replies.

Thanks all for the replies.. Would atf harm the seals?