Recent content by Ursatdx

THanks for that.

Cases sure look abused for once fired brass. Do tell.

I worry I don't worry enough. Should I be worried or am I just overthinking things.

I'd get it looked at. A spider bit me on the arm at a dirty hotel near Watkins Glen. When I woke it was making its' way back up the web strand to the ceiling above. Tiny little thing left only a small bite mark. In the week following the race the bite continued to grow until it was golf ball...

We are stardust.......

Check engine oil for contamination. Most likely the pump oil and water mix is what you see.

This one was.

I always back in. Boat, too.

I've installed a ton of P-gasket filters. Never would I want even the slightest metal to metal contact. "Appears to be touching" leaves some significant room for error. Ever have to deal with one that is overtightened? I have. I actually prefer the P-gasket but not the consequences when...

Perhaps a used diff might be better.

You can rent discharge hoses in many diameters.

In New Jersey, slingshots are generally not legal to carry in public without an explainable lawful purpose, and possession can be treated as a fourth-degree crime under state law. I led a childhood of crime. Large capacity pants pockets filled with lethal marbles.

I did my Tundra through the transmission cooler lines for the fluid change. Used the dash sequence to check transmission temp. If you decide on a filter change be careful with the 10mm transmission pan bolts. Looks like you're in the rust belt and these bolts are very easy to break off...

I have two on the deck/blade spindles, two on front tire shafts, two on the steering pins. I'll look for the one I'm missing unless you have a diagram. Thanks

New oil/filter when put away. T6 5w40. Napa fiter. Battery charged monthly in the basement. Put a fresh sharp set of blades on. Greased the spindles and front wheels. I think there's another zerk on the steering. Cut the grass at 2 3/4" to clean debris. Just hit 200 hrs. Home Depot Deere. 17hp.