Recent content by mrbreezeet1

Bring me your weak bring me your dead.......... .... SR44 batteries please. Someone or more than one of you follows that goes through a lot of these batteries would you mind throwing your old dead ones and weak ones as you replace them in a can somewhere and when you get about 50 or so send...

Please, lets not condemn the tranny before its time.

The hard shifts are due to the line pressure being maxed out, True, But It will return to normal pressure after a key cycle. Keep seeing slow, long shifts, pressure back up!

Not Most Likely Toast.

Yes! I have 2 words for you! Yes, Shift Kit!

I was asked to post the tail stock I came up with so here it is. I used brass 3/8 coarse threaded rod and 2 quarter inch air tool plugs, cut down and threaded. Also I threaded the tail stock aluminum section to accommodate the quarter inch pipe thread of the air tool plugs. Used an additional...

" I think they are just trying to weed out the Garage Sale and Flea Market humpers who buy trashed out tools and then submit all at once wanting a warranty replacement" That's exactly what they are trying to do weed out the flea market buying broken snap-on tools and returning them for brand...

https://bobistheoilguy.com/forums/threads/2002-acura-tl-does-this-sound-like-the-main-relay-is-bad.373007/

Really sounds cave-man like, but of course the old "Down&Dirty" method to test for a loose/poor solder joint. See my post about the Acura main relay(s)

Me too! They asked me, Where l got the tool, I'd say, Well, well just called him "Norris" Heck l don't know or never knew his last name, when l worked circa 1994 to 1999 @ Snyders auto on Campbells run rd, Carnegie Pa! New tool at my door shortly!!!!

I'm running that Flash SlimJet Too. Plays real nice with my total system(s). Blows Edge out of the water in my application!

N0! My Mistake, It is/was a 8GB. Sorry for the confusion.

Yes, Indeed they do. It's like $20.00 usually I think/depending on price of item l think?

They MUST! or they will get after them I'm pretty sure.

greaseing the zerks if it has e'm and spray the whole jack, well all the moving, possible metal to metak contact points with a PTF or the like lube, and then some silicone on top of that. Even a little brake slider lube if you can. Look for "witness marks" too, and file down that contact area...