Have all these Honda in the signature and have some Mobil Delvac HDEO 15W-40 and Shell T6 Rotella 5W-40 laying around.
Can I use it after making a brew with regular 0W20 or 5W20? Or should I just keep diesel oils for motorcycles and OPE!
Thank you :D
Planning to do it now and use these ones: https://www.autozone.com/ignition-tune-up-and-routine-maintenance/spark-plug-non-fouler/p/dorman-help-18mm-gasket-seat-spark-plug-non-foulers-2-pack-42009/730544_0_0
Should I use the gasket/washer on the fouler or no need for it? Thanks
On my 2007 Honda Pilot AWD with AT - getting P0420 and CEL is on, randomly it goes away on it's own.
Cleared it up via battery terminal reset and back again after few hundred miles.
Now have to get the emissions done and can't do it because of this code.
Do I have to replace the CAT or would...
Thanks @paulo57509 - mechanism does seem fine with movement and caliper can be compressed. Removed cable from the spring on the caliper and had to use brute force to pull it out, meaning it is coming back once lever is released. Is this an expected behavior?
Will be receiving a new cable...
Did notice from the beginning, with lever action rear driver side was moving in and out, while passenger side was stuck as the exact same point and no impact with hand brake.
That is why suspecting actual cable is bad, now thinking could it be a caliper? Appreciate any thoughts? :)
Yes, did check after removing from the caliper - once brake lever is pulled it does move, but does not come back once lever is released and needs a lot of brute force to budge and still does not come out all the way - does it mean cable is bad or caliper issue?
So passenger side rear parking brake cable isn't moving when hand brake inside the car is being pulled or released.
Driver rear side moves freely, anyway to unstuck or to get it free?
Similar behavior as this one in the thread...
Trying to fix a siding trim board, as it is peeling off? What is the best way to fix it?
Like use screws or drill through and use an anchor or nails?
Will be doing it for the first time so would appreciate input and help: