Recent content by bcossa2020

I think anticipation of watching a movie others have liked has an effect on my perception. Ghostbusters was just plain awful…I tried to watch Butch Cassidy and the Sundance Kid a couple of weeks ago and was bored after an hour and turned it off…. Really enjoyed the first 3 Stars wars movies but...

Al Pacino….

I use Simple green, but just spray everything and let it sit. If something is super dirty I’ll spray it again. Might hit a bad place or two with a toothbrush. Then I hook the hose to the water heater drain and lightl, slowly, mist/rinse it off with the hot water. I used the Castrol Super...

😎😎 I’m accustomed to seeing the Magnahelic gauges on air handlers…..yours sounds Impressive…..

Split level house. Currently it is 74 degrees outside. Stat, which is on the upper level, is set for 73 and cooing is running. Temp downstairs is 65 degrees. Temp upstairs is 74 degrees. I realize these are “spot” temperatures so I am going to take multiple temp readings over all of the...

I'm thinking of doing some investigation on my home HVAC system and am looking for a decent tool to check the static pressure at the unit and in the ductwork. Would like to keep it under $100. Any HVAC technicians with recommendations??

It may be painfully obvious to everyone but me but I’m learning that the trim needs significant attention at every wash..,,

One time I connected a small vacuum pump (I bought for AC work) in place of the hand pump……WOW. I have not done it since…..😎😎

I can’t find a price on this product. Where do you buy it????

I can‘t get past the economic difference between the liquids and paste. $20 for a 14 oz can of Finish Kare at 6 months per coat. Mothers wax lasted maybe 2 months. How often are the spray waxes applied? Surely more frequently than the paste….like maybe every time you wash?? Certainly it’s...

I will be following this with interest. It’s difficult for me to express the level of disappointment and frankly disgust with Mothers Back to Black performance on my trim. They should be ashamed to advertise it and I will certainly be more diligent when researching their products in the future.

Flush brake fluid on Fusion. Discovered that the bleeder valves on the front are a different size than the ones on the rear 🙃😬

I acknowledge the previous posts concerning the cleaning of the webbing. I cleaned my seatbelt with a 5:1 solution of Woolite using a scrub brush and there was a noticeable difference in the retraction speed. Lots of YouTube videos on cleaning the seatbelts……..

Perhaps some members have successfully patched concrete to a durable long lasting surface/product. In 35 years of commercial construction I have seen zero successful “fixes“ that lasted any length of time and did not look like a patch job……and I don‘t experience the freeze/thaw/cycles and salt...

Thanks for responding. I have trashed the entire assembly 😎😎