Valvoline Engine Armour 10w30 + 2/3 bottle of Liqui Moly MoS2 @7,000km. 205k on engine at time of sample.
It's a pretty basic test but it looks like that intermittent slight knocking on cold starts isn't much to worry about yet!
Iron - 4
Copper - 4
Aluminum - 2
Lead - 1
Silicon - 20
Sodium - 253
Fuel - 0.1%
Not sure if this can be read properly as it is a screenshot.
Wear metals are looking really good despite the report coming back as 'caution', but this is because of the high sodium levels, which is used in Valvoline's add pack so no worries there.
Silicon was a bit high because i found the crankcase breather hose off near the end of this OCI and unfiltered air was being drawn into the engine.
Water was 0.1%, nothing drastic but interesting since I do a lot of highway trips.
Viscosity was said to be high too which could be down to the MoS2 additive?