Form a gasket fail

Looks like success! Thanks for helping I really appreciate it. Now on to the final project for this car. New rear springs!
 

Attachments

  • 20201210_152106.jpg
    20201210_152106.jpg
    102.1 KB · Views: 31
Not clear, which product did you decide upon?
The ultra black because that's what I already had. If that didn't work I would have gone with one of the other options. I didn't wait an hour I just slowly tightened it up. Not real tight. Could not use a torque wrench because of clearance. Winter has kicked in so it's not clean underneath anymore but it looks like it's holding. I think it was the coating on the pan. It was too smooth I needed to rough it up a little bit.
 
Back
Top