CV axle end slightly bent ok or trash?

Status
Not open for further replies.
Joined
Oct 8, 2011
Messages
3,492
Location
Madiganistan/Chiraq
So I bought a CV axle off eBay for less than 1/2 price ... It is an OEM part but the end is a little bent
I think this part is a dust cover for the trans seal?

Is there any problem with very gently straightening this out ?
The hub end had a tiny bend but I straightened that side a bit already

IMG_20191006_154750.jpg


IMG_20191006_154754.jpg


IMG_20191006_155213.jpg
 
Last edited:
Get it as round as you can then try it. If it doesn't rub on anything or interfere with the seals I think you're good to go. Just be careful when inserting this in the tranny not damage the oil seal.
 
Status
Not open for further replies.
Back
Top