2007 Mitsubishi rear brakes

[speer]

I can't get the rotor off due to the ebrake Does anyone know where the adjustment is off hand or any tricks to removing the rotors? Thanks

 

[speer]

I got it. There is a rubber plug on drum part of rotor pop that out and put on bottom , look for the adjuster (star) adjust to loosen (bottom to top) then thread 2 bolts in threaded holes and tighten evenly till it's off. Need about 2 in. bolts I don't know thread size I just pulled 2 out of bolt box and they fit.

 

[duaneb9729]

Thank you for sharing your experience's!!

 

[speer]

Originally Posted By: duaneb9729
Thank you for sharing your experience's!!
I like to finish a thread with the answer or outcome so someone searching for answers and finds a thread finds a answer not a deadend

 

[Falcon_LS]

Which Mitsu is this for, sorry?

 

[speer]

Sorry never did say did I it's a 2007 outlander (4WD)

 

[Falcon_LS]

Thanks for sharing! Those are great vehicles...I used to have an '08 OL.

 

[speer]

Also found that so much rust built up under stainless slides that brakes were locked tight. Needed to use hammer to get pads out of slides (anti rattle clips) so I removed clips and filed rust away then applied neversieze shouldn't happen again