Our beloved 2006 TSX has 1 broken and 1 cracked fog light lens. Is it necessary to remove the bumper or can they be accessed from underneath?
Thanks in advance.
Thanks in advance.
2006 Acura TSX fog light replacement question.
- Thread starter JeffKeryk
- Start date
No need to remove the bumper. Here's a YouTube video explaining the steps. It unbolts from the rear.
Acura tsx fog light removal
Acura tsx fog light removal
I did see that video; he's not real clear on the plastic trim piece replacement. It could be glued or something. I will give it a shot. Perhaps bottom access will work. Thanks!
JHZR2
Staff member
What does the FSM say? They usually give the best method. Lots of lights do come off/out from inside/under the hood, but fog lights are pretty low for that. Is there a belly pan/plastic cladding underneath that is clipped to the bottom of the bumper or the metal structure? My accord has that, and I suspect removal of the little pop in clips and dropping the plastic would give lots of access from behind/under.
This was great advice. There were a few approaches, either from the bottom or just remove the grille. But the consensus was, removing the bumper cover can be done in "5 minutes" and is nothing to be afraid of. Just a couple of 10MM bolts and maybe 10 push clips, then the bumper pulls right off. The lights are right there.
Thanks; I will order the fog lights and get crackin.
Last edited:
If replacing I would go with some Diode Dynamic LED or Morimoto LED versions. The DD are brighter then the MM I have on 2 different cars.
If you go factory with glass lenses, get some headlight film to cover and protect them afterward. Headlight Armor, Weathertech, X-Pel, Lamin-X and many others.
Check my post on DriveAccord with links and videos. Headlight Protection film.
If you go factory with glass lenses, get some headlight film to cover and protect them afterward. Headlight Armor, Weathertech, X-Pel, Lamin-X and many others.
Check my post on DriveAccord with links and videos. Headlight Protection film.
