2005 Honda Accord V6, factory fill, 466 miles

Status
Not open for further replies.
Joined
Aug 28, 2002
Messages
308
Location
Houston, TX
we had purchased the car literally the day before evacuating houston due to hurricane rita. we sat idling for ~10 hours. i changed the oil a few days after returning and took this sample to see how it weathered the evacuation.

code:

Al 3

Cr 1

Fe 16

Cu 24

Mo 328

Mn 38

K 3

B 201

Si 86

Na 8

Ca 1591

Mg 10

P 620

Zn 710

Ba 1



SUS 51.0 @ 210° F

Flash 380° F

Fuel
Insolubles 0.2%


anything not listed above was reported as 0. blackstone's comments:

"All that idling didn't hurt a thing. Your new Accord handled it like a champ. Wear is mostly
around averages, though of course this oil was only run 466 miles. Still, all the metals were in the
correct balance and nothing was out of line that would show a problem developing. Silicon was high,
and that's left over from sand-casted parts and sealers used at the factory. It should drop nicely next
time. The viscosity was a little low, so you may have had some fuel (that has since cooked out) shear
the viscosity during the idling. Otherwise, looks great! Check back."

enjoy!

-michael
 
Multiply all wear metals by 10 and for a 5k breakin period, it looks good.

[ November 23, 2005, 03:31 AM: Message edited by: ex_MGB ]
 
Status
Not open for further replies.
Back
Top