Search results

My daughter just bought a 2015 Honda CRV with the CVT. It has about 38k but I am planning to baseline all the fluids with fresh fill in the coming weeks. My question is about the Honda HCF-2 fluid vs. the Redline CVT equivalent. In the past, the Honda fluids were mid-pack. I've had good results...

The Search function didn't help much so I thought I'd just ask. I am going to replace the upper and lower ball joints on my old (1991) Ford Ranger. OEM and Moog or off brands are on Amazon or Rock. Are Mevotech or Centric worth considering? Any preferred brands based on your experiences...

I have a 1991 Ford Ranger, 3.0 Vulcan V6. 86k original miles. I suspected the fuel pressure was off, especially for idle right after hot start up. Got a fuel pressure gauge on the tool loaner program at AZ. The pump seems to test fine; factory specs the range of pressure at 35-45psi. With...

I've got a '91 Ford Ranger 3.0 V6, 83k original miles. It's leaking from just about every gasket/seal: oil pan, rear main, timing cover, etc. I have to pull the engine to do the rear main, plus gain access to the pan/front cover. And no, I can't do it all with the engine in the truck; too little...

I have to replace the rear main seal on my '91 Ranger 3.0 V6. I see there are the two gaskets types available. Any thoughts on which is prefered? Or even which brands? I tend to lean toward silicone but that may be dated information. I only want to do this once. Thanks!

I have a 1991 Ford Ranger that I may need to replace the ECM. I am getting some diagnostic work done soon. I did the usual dist cap, rotor, plugs, wires, etc. Also replaced a variety of sensors that have improved an intermitent rough idle. All helped, but none did the job. I am beginning to...

ALERTS TO THREATS IN 2011 EUROPE : BY JOHN CLEESE The French government announced yesterday that it has raised its terror alert level from "Run" to "Hide." The only two higher levels in France are "Collaborate" and "Surrender." The rise was precipitated by a recent fire that destroyed France...

I have a 1991 Ford Ranger 3.0 V6 Vulcan pushrod engine. It has original 75k (I bought it from the original owner). It has an intermittent idle-speed knock up to maybe 1500 rpm. It can happen cold, warm, hot. It usually happens at idle without accelerating and will start knocking sitting at a...