Search results

Thanks The LawnRanger that eliminates the gear sold on Amazon. It is sad that no one makes a metal replacement gear.

I am looking for the best replacement blend door actuator motor for a 2009 Impala. I replaced two blend door actuators on the car 4 years ago with new Delco's #1574122 and now one of those has striped its gear. I checked both blend doors when I replaced the actuator's and both doors turned...

Don't forget if your old battery has a plastic strap handle on top of the battery save it. The new batteries do not have the straps but still have the slots for the strap lifting handle.

Well I am still looking for a six foot long ring terminal cord . The no name versions from ebay (picture in above post) are junk. Batteryminder used to sell RTA-7215 don't know why they dropped the part.

Well the 7-ft long version's on the bay have had the fuse section and ring terminals added. It would be nice to find something that has not been cobbled together.

Thanks HorseThief I watch out for polarity differences.

Does anyone sells different length 2-pin SAE ring terminal quick disconnect for battery maintainer's. So far all I have found is 2-ft. long and 7-ft long ring terminal connectors on ebay. Guess I can buy the 7- foot and bundle up what is not needed.

Thanks.

2015_PSD what is the color and consistency of that Fel-Pro C-100?

Joegreen nice fabrication and nice pictures Sometimes you can find those new on ebay.

Thanks P10crew & RooflessVW that is what I wanted to know. I hope some one marks them down Monday.

A question for Battery Tender Plus owners. On a Battery Tender Plus what happens if 120-volts is turned off and back on after a while like in a power outage? Will it power back up and continue maintaining the battery like nothing happened?

007 what carburetor are you asking about.

Yes the problem may be in the pump but it is easier and cheaper to drop the pan than to drop the trans.

007 do some research and see if you need a deep pan filter conversion kit. GM used a deep pan that took a longer pick up tube and a longer bolt. If I remember correctly I would use 2 o-rings where the tube goes into the case to prevent air leaking in.

Decent 3-oz grease gun? I see that Mystik JT-6 High Temp #2 is available in 3 oz tubes and was wondering if any one makes a decent 3 oz gun?

The upper plastic intake manifold exploded on my 96 Regal in 2007 with 67K miles. This happened because #2 Bosch injector leaked fuel over night. The explosion happened just as soon as I turned the key. It was so bad it pushed #2 injector out of the lower aluminum intake manifold and bent the...

The 3800 II motor has the cover there for two reasons. !. Noise damping. 2. Scatter shield if the car back fires from a leaky injector it can throw deadly plastic shrapnel

User52165 that is a good idea I will try that tonight.

I need to find a 90* rubber elbow to replace the bad one. This vacuum line runs from the front of the motor over the 3800 plastic intake manifold to the back side of the motor. If I go from a ¼" O.D. hard line to a ¼" rubber hose the O.D. will be 12-mm and will not want to fit under the motor...