Every Casino had a sports gambling lounge. That’s a joke now because you can do the same thing in your living room with smart phone app. I’m thinking on-line gambling has knee capped Vegas.
Turns out the drums I got on back order from Canadian Tire were coated on the outside surface. I degreased them and applied a couple of coats of silver engine paint. With the star wheel assembly retracted to its minimum length I was able to carefully center the shoes and slip the drums on with...
I have the 2008 version. Highway driving really saves that transmission. I have 275,000 miles on it and am the original owner. Watch your oil pressure. I replaced the O ring on the oil pickup tube. It eventually gets brittle. Still have the original water pump and starter.
The Motive system has a large of volume ( as large as you choose). The brake master cylinder had fairly fresh fluid from a previous turkey blaster job. I pushed all the volume of the master brake cylinder out through the bleed screw into the bottle plus a goodly volume of new fluid, leaving the...
Although they aren’t stainless steel, the bleed screws I bought are a step up from the corroded ones. I used a tubing loop and plastic bottle with the tubing submerged in it. I used a Motive Pressurizer with the correct adapter to the Ford brake cylinder. I found it easiest to start the engine...
When I purchased my 2008 3/4 ton Suburban, the current oil was SL. Then I kept up with SM, SN and now SP. The engine has 275,000 miles and doesn't use oil. Use the SN and sleep well. ;)
This might be a good place for my post. My last set of solar post lights had decent sized panels but cheap Ni-Cd 300 mAh batteries. Also, they were LED and not the old diode type. They finally died so I ordered these N-MH 1000 mAh batteries in the same 1.2 V voltage. The batteries were much...
If you are one of the guilty folks who slam in a can of AC charge to "top up", this video from FordTechMakuloco goes over how to figure out you went too far and overcharged the system. Enjoy.
I’m planning on using my pressure bleeder on my Ford Taurus but before that I plan to pick up some stainless steel bleed screws. The originals on my 20 year old Taurus are totally rusted.