Addendum: I found no answers in the FAQ section of the FP/LC site did not find an answer. I looked before I posted but didn't mention that I looked...my bad.
At this point I going to go with the IAC, followed by the TPS. Even if I replace both of these it is still cheaper than taking it in for a diagnostic at any of my local garages. Thank you for all of your help and wish me luck.
by "racing" I mean it will start and rece up to 3000 rpm then kick down to 1500 to 1100 or so. It only races like this after it's warmed up. In the mornings it hardly does it at all. It has never done this before until about a month ago. The idle never drops below 1100 regardless of the...
Anyone know why my engine would race(high revving upon start up)? I've checked all the vacuum areas as well as changed the O2 sensor and re set the computer. Any help is greatly appreciated
Car: 1993 saturn SL 1
Took a degree in History. Why? A college professor talked me into it. He said that pretty much all I needed was motivation and I'd do just fine. Turns out he's right. I don't make $70,000 year but I make enough to be happy and do the things I want to do. When people asked me if I knew how to do...
Hootbro,
Not sure where the ammo came from, it was brass cased. I'm probably going to stick with the new stuff or start reloading my own.
The M44 are extremely difficult to find; at least they are in my neck of the woods. I consider myself very fortunate to have found the M39 when I did.
Hootbro,
You only have 10? My son, go out and get thee more Mosins'
Do you have any Finnish Mosins'? I have a Finnish M39 and I noticed immediately, when I compared it to my Russian 91/30, that it is a much superior made rifle.
I figure I must have had some of the Albanian stuff as my bolt refused to open without the help of a mallet. I cleaned the bore area using a drill and 20 gauge brush as this was suggested by MosinNagant.net but it still happened. I don't see that there are any burrs in the chamber area so I'm...