Recent content by saskman

I recently picked up a set of Wagner Lighting 9005 Headlight Bulb's BriteLite Xenon. When I checked the bulbs in the box and they were made by philps. Now are the britelite xenon the same as philps CrystalVision Ultra. the only difference that I can see between these bulbs is the CrystalVision...

I need feed back on Philips Crystal Vision Ultra light bulbs. How long are they lasting, are worth putting into your vechicle? Are they brighter than Silverstar light bulbs? The price is good just want feed back on them. I was going to put them in my 08 tundra for the high beam. As well I cant...

Try Canadain Tire for K&N. Not sure about Bosch or Mobil, I think that Mobil is in the states I think and not sure of Bosch. I am sue there will be other that will chime in. Try phoning around to your local automotive supply shops, eg Napa, etc.

I would like some input on 9005 high beam bulbs for my 08 tundra. What i want is a little more light on the highbeam, than oem bulbs. I have done some researching at the local shop and online as well. I found the following: 1) Piaa: xtreme white plus and INTENSE WHITE...

I you use Amsoil Synthetic Heavy-Duty Grease NLGI #2, the grease offers excellent water washout resistance, and I have ran this in all my moutain and road bikes. it tends to stand better in extreme conditions mud, water, etc and from washing the bikes. Mind you I am a aivid cyclist and repack...

What kind of grease is everyone using. I am trying the Amsoil Synthetic Multi-Purpose Grease, NLGI #2. I thinking long term, and the weather in Canada, going from one extreme to another, I dont think it wont hurt running a sythetic grease in the drive shafts.

Ok I greased my tundra yesterday and the back three u-joints were easy to grease, thus rear wheel drive and rear axle gets the most use. The front axle by the transfer case was very hard to get any grease in the u-joint. So I thinking that the grease gun wasn't on the zerk, and tried acouple of...

When greasing U - joints, Should there be greasing out of the u-joint or not. If you over grease a drive shaft and pop out the seal , is that an indcation of a U-joint replacement. I dont know if this topic has been talked a about or not, but please direct me to the thread that has been started...

I am currently running 0x30W Amsoil in my 2008 Tundra and I am wondeing if the 0x20W will be any better, in the 4.7 engine. The 5.7L engine runs 0x20W. Would I notice any benfits from running a little oil than what I m running at the moment.

Im running amsoil in my lawn mower. I changed it last year and checked it this spring and was pretty much still clear as new oil. Mind you i use the lawn mower once a week in the summer months. Thinking about changing the oil this week.

Is there any diffeence between Denso iriduim plug and a NGK iridium plug, or are they pretty much the same. I do perfer NGK's over other plugs that i have tried. My other question is i checked my truck plugs (8 cylinder) and have a tan color on the insulator is that normal on 30000km on a irdium...

Thanks, i m new to this forum

I recently checked under the hood and notice the res was low and have to add anitfreeze. I m 200km from a toyota dealer. Is there a substuite coolant to top the res tank. I m thinking of changing the antifreeze over and run a more common antifreeze that i can pickup around town. I have been...