Recent content by Chuck61

So I decided to get the secondary thermostat and replace that as well, because why not? I can’t find any videos of anyone doing this however, and the diagram on the subarupartsdeal website isn’t very helpful. Maybe I’ll swing by the dealer and ask if I should replace it or leave it, the parts...

I have the NA. I bought the larger stat for the lower rad hose, not the small one for the cvt. I bought the Calorstat.

My Forester doesn’t have a temp gauge, just dummy cold/overheated lights. I’m using an OBD scanner for that number. I paid a little more attention today and after 195, 199.4 stuck around for a long time I the highway. Not sure how accurate that is either though.

Not trying to gain anything, just bought the wrong spec and it isn’t worth returning cost wise. The heat is warm, and the cold dummy light goes off, at around 95F. It seems like 195 is the spot where the temp hovers for a while, so I’m guessing that’s where the stat opens? At any rate, I think...

Hi Everyone, I’m getting ready to perform my first coolant change on a 2015 Subaru Forester with about 130k. I bought a new thermostat to replace the original (which is still operating normally). I realized that the one I purchased on RockAuto opens at 188F, while the OE temp is 192. Will this...

Hadn’t really considered the hammer blows, but yeah, those probably helped quite a bit.

Probably would’ve been, with much less day-after shoulder pain. I bought screw extractors, a propane torch, a can of liquid wrench, some anti-seize, some socket adapters, and I’m sure more that I can’t think of, for what should’ve been a simple job. At least I have that stuff now. I’ll save the...

So I figured that I’d just buy a new cover and gasket at this point, and go that route. But the rear Diff cover on Subarus has mounting bolts that go through the crossmember, which means I’d have to drop the diff a bit to remove the cover, which could be a huge pita. So I figured I’d give it a...

Yeah, I think I’m back to this

Ah, I see what you mean. If the bolt breaks off in the Diff housing it’s a high pita

Well, I haven’t done anything else yet. I haven’t even had time to swing by the shop and see if they could break it free for me. I’m just curious though, what kind of damage are we talking? Couldn’t I just replace any broken bolts? (I really don’t know)

Yeah, I’m not sure how much of the liquid wrench is getting in there. Probably not much. But it couldn’t hurt, I guess. Would you recommend drilling into the plug while it’s hot? I have a little butane torch that probably isn’t as hot as a proper propane torch. Would that do the job?

I’m glad the wrist is feeling good. Sounds like a heck of a journey. I would like to hammer in an oversize bit but the chassis is in the way and I really can’t get a good swing on the fill plug, especially laying on the ground. If I can get it out, I’m not even messing around with the drain...

I figured the 20 degree weather we’ve been having at nights would do the job, but apparently not. 🤷

So I’ve decided to got the patient route for now. Picked up some liquid wrench and I spray that on there a couple of times a day. I also picked up a heat gun at harbor freight and I’ll try hitting the plugs with that a few times over over the next few days. Then I’ll see if I can use the bolt...