Yes, there is a pin. I believe this pin is for adjusting it right to the booster. If I even just touch the pedal it starts to brake so I don't think that is issue.
I have had E3 pads on some of my vehicles. Actually have them on the RSX right now. Amazing pads. It actually doesn't firm up the...
Are bolt hole distances on MCs standardized? I think getting the correct diameter of the MC to fit into the booster is going to be hard. Unless that is standardized as well
So I have a few options then and would like your opinion
1: deal with it as is
2: get more agressive pads. Less modulation but less travel, however, the pedal will remain light like it is now so it may just become very difficult to modulate
3: figure out how to fit an MC from a truck. I am a...
Motorcycle or bicycle? I know there is a master cylinder piston adjustment but I think it is good. If you jsut barely touch the pedal it begins to brake. It's jsut it travels multiple inches to get to full power. And by full power I mean 120 mph slamming on the brakes right just before ABS kicks in
I do understand this but there is no upgraded MC for these cars. Stock is a 1 1/16. I cns get a 1 1/8 but that's going to be hardly an different. Ideally I would have a 1.5 or even 2 but I know of nothing that has that size outside of an International truck
The reason is heel toe. I need to be able to press press the brake and gas at the same time on track. So if the pedal goes further down the the gas I cannot do this. Right now I have tons of shims behind a race pedal attached to the brake pedla to move it back. But it's quite high up and a bit...
I have three cars. One of them is a track car. I have bled the brakes multiple times on all of them. On the track car when I slam the brakes on the circuit I need to push the pedal sooooo far. I noticed its the same way on the van and the RSX.
To my understanding I thought a brake pedal should...
Usually when I get rotors you can see on the outside edge a milling mark where they have balanced the rotor. I do not see any milling done on this rotor yet Raybestos claims these are mill balanced. All I see is this little nub which looks cast. Is there another way to mill balance a rotor that...
It just comes out as a gummed up "glue" now. I slapped an OS Giken 100% lock LSD in there so intilaly then ring and pinion had to mate up again. Changed it after 500 miles and then again after 3000. It had quite a bit on there after those two. Last year there wasn't too much on there.
But...
Any misgivings about this being mounted horizontally instead of vertically? In terms of strength that is. It is OEM so I assume that magnet is stuck in there pretty good
It's an 07 350Z I mostly take the track but it's still street legal.
I was thinking #2 would work just fine. Plus I change the fluid before every season. I could always run it for a year and check the fill plug to see what it has picked up. I also assume it gets sloshed side to side quite a...