Recent content by blownpickup

Thanks Jim, after countless hours researching this I came up with the same .040 orfice. What I have done is Drilled the .0625 restriction out and tapped it 10-32 to accept a carburator air bleed jet that is .036. From what I understand the Amsoil restrictions are .030, I will still do a flow...

Don, with 10 gal of oil .100" may be ok for your application. From what I understand, driving at 45 mph on the highway it should take 15 min to filter the intire sump. For my application of 14 quarts of oil it should take 14 min @ 1 quart per min.

I think checking the flow rate is more than likely nesessary after the bypass system is installed but it would be nice to get it right the first attempt. I think less restriction is better than not enough. I would hate to see a pressure drop in the primary oiling. The bypass would just take...

I may have been mistaken on the 1 gpm, should be 1 quart per min. I am surprised that some of the more experienced gurus on this site have not responded to this.

I am installing a oil filter bypass setup on my 6.0 Powerstroke diesel. I have purchased a Fleetgaurd LF777 filter with a #3304173 remote mount. I believe the filter flows 2 gpm and the mount has an aprox. 1/16" (0.0625)restriction built into the outlet. Is this the proper size restriction for...